Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Need to replace 'O' rings and Gaskets in Delta Faucet
[ 1 Answers ]
My Delta faucet which is probably 30 years old constantly drips. I have replaced the shower head so know it is the faucet. It is a single handle push up for on and twist to the right or left for temperature control. How do I replace the o rings and gaskets? Thank you
Old Delta bathtub faucet renovation
[ 21 Answers ]
I have an old Delta two handle shower/tub faucet. I've seen many posts on this forum about how to remove the tub spout, but none seem to apply to this spout. I've taken pictures of the underside of the spout to show what I mean. There are a couple grooves, but no slot where an Allen wrench could...
Delta faucet cartridges .
[ 1 Answers ]
I recently replaced both of the seat cartridges in our lavatory faucet. They work fine now and don't leak anymore. But during the past few weeks they have become more hard to turn on and off. Is there a reason for this that anyone knows of? It almost feels as if something is tightened too much, but...
Delta two handle faucet
[ 1 Answers ]
I have a Delta two handle knob faucet in my bathroom. It had a very irritating leak so I purchased knew knobs and replacement parts at Lowe's. I replaced everything down the seats and springs... (except I think what's called the stem) At first, when I turned the water supply back on, the water...
Delta faucet gunked up
[ 4 Answers ]
I have a Delta Faucet model 173 `Waterfall' which has the single handle separate from the spout. After I did some plumbing work the flow is low which implies it is `gunked' up. I need to know how to get the handle apart to clean it out. I got the Handle off easily and the Adjusting Ring (part... View more questions Search
|