Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Thermostat wiring for heat pump
[ 1 Answers ]
I am installing a Honeywell RHT7000 thermostat. My wiring harness has a r, o,y,g,c, and w1. On the old unit e and W1 were jumpered. What do I do when the instructions say to contact a contractor if the new wiring scenario has a w1?
Heat pump thermostat wiring
[ 1 Answers ]
I have pored over the thermostat wiring messages on this forum, but I still have a question. I am installing a RiteTemp 8085C to replace a Janitrol thermostat for my Goodman heat pump. The old thermostat was wired as follows: Red to R Orange to O Yellow to Y Green to G Blue to C White...
Wiring from transformer to heat only thermostat
[ 2 Answers ]
I have a honeywell hot water heat system(condo) with a control valve for the water, a transformer to supply power to the valve and a thermostat. The power supply was disconnected and I now need to reconnect a new transformer into the system. I have tried to use a 40VA transformer but I am concerned...
Basic heat only thermostat wiring question
[ 5 Answers ]
I am replacing a Mears w/ a Lux LV2-1042: Double Pole, Line Voltage, Heating Only Thermostat. This is radiant floor elec heat. Am not sure which wires connect to which. The thermostat has 4 wires (2 red, 2 black) Out of the wall comes, from the top- 1 black wire (hot), 1 white (neutral) and the... View more questions Search
|