Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Tub Drain -- 1 1/2"pvc to 4" cast iron with hub
[ 12 Answers ]
Hi . . . I'm replacing my old cast iron tub with a whirlpool tub. The old drain was a 1 1/2" brass tube tucked into a 4" cast iron drain pipe (with hub), packed with what might be oakum. The seal was fibrous and waxy when I cleaned out the drain, and that's not MY hair :) What's the best way...
Adding a PVC "Y" to a underground Cast iron pipe
[ 1 Answers ]
I have a house built in 1962. The cast iron waste pipe runs under the concrete slab in the basement. I have already dug and confirmed the location I want to cut a section out of the pipe and install a "Y" connector and run new plastic waste pipes to a new bath. I have seen PVC connectors that...
Cast Iron: plug stuck in 3" x 1.5" Tee
[ 5 Answers ]
Hey there! I've got a 3" cast iron soil stack, with a 1 1/2" Tee fitting which has a plug in it. There's some goop at the joint, it's pretty hard. Not quite JB-weld hard, but hard. It's beige colored. There's not a lot of room in the space, but I've gotten an 18" pipe wrench on it and i...
Can I replace part of my cast iron sewer stack.
[ 3 Answers ]
I have a hopefully not too stupid question about replacing part of my cast iron sewer stack. I have a 50+ year old house with roots in my sewer pipe causing some backup thought the basement drain. I used root killer in the drain and several weeks later had a mat of small roots flush back up...
PVC to Cast iron "Speed bump"
[ 1 Answers ]
Hello all, I call this thread the speed bump because when I dug out my basement floor to replace an upstream section of cast iron pipe with new pvc pipe for a bathroom and to move my stack, the downstream attachemtn to the cast iron pipe is now giving me some mild trouble. The cross section of... View more questions Search
|