 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
94 GMC clutch
94 GMC Sierra 1500 5 speed
The problem: push clutch in, put in gear, let out clutch without touching the gas and it just sits there. If I keep giving it gas it will move after 30-60 seconds, but it does it going into every gear if I try to drive it down the road. Any help would be great. |
||||
|
||||
|
Well, it could be the clutch disk but that would normally give you chatter on release. I'd suspect a binding slave cylinder that isn't releasing the clutch fork properly. A worn ball stud is another less likely possibility. They can get kind of pointy as they wear and since it's the pivot point, the clutch fork gets jammed. However, I'd start by checking out the slave cylinder.
|
||||
Not your question?
Ask your question
View similar questions
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
Gmc heat
[ 1 Answers ]
I have a 2004 gmc truck but my heater stops working when the engine rpms runs below 1500 rpms(idaling)the fan works great but blows cold air :eek:
Gmc truck
[ 2 Answers ]
My 1982 gmc truck won't start sometimes and will stalled sometimes.When it decide to stall on the road or just iddling its just as f the motor died no missing or no noise of anykind its just dead.When it doesn't start I only fires once when I release the key and it sounds like a little back fire...
Gmc pickup
[ 1 Answers ]
I own a 1982 gmc 1/2 ton pick up. The transision will not shift out of low gear. When you hit around 15 or 20mph and shout off the gas it is like it goes in to nuturl. Years ago when this hapend I changed the "vacum modulator" and I would be off again. I looked EVERY WARE on the...
View more questions Search
|
