Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Maytag dryer heating element wiring schematic
[ 0 Answers ]
I have a Maytag dryer model#SDE5401AYW and it quit heating. We purchased a new heating element and went to hook it up but we have two gray wires that come from the wire harness at the motor that we have no clue where they go. My father-in-law took out the old heating element and didn't mark the...
Enamel on a Tub
[ 1 Answers ]
I plan to work on a tub for a tenant of mine. He has not taken care of it in any way. The tub is badly stained with little or no enamel left. The splashguard made of fiberglass has been painted and is peeling. There is mold in many spots. I plan to thoroughly clean and scrape all the paint,...
Fixing an enamel tub
[ 3 Answers ]
My mother's tub has a hole rusted through it... its an old rectangular enamel finished tub... might be a steel or cast iron not sure.. I thinks its steel because the hole isn't that deep and I can almost my finger through it... pretty sure cast iron is much stronger... any way to repair this short...
Heating element stays on after drum stops
[ 8 Answers ]
To stop the dryer we often open the door. When I open the door the drum stops turning. The heating element remains on. If I turn the timer to off the heating elelment will go off. If I set the timer to on the heating element starts immediately before pushing the button to start the drum. What... View more questions Search
|