Ask Experts Questions for FREE Help !
Ask
    ejbmw214's Avatar
    ejbmw214 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 29, 2008, 08:46 AM
    Change an ignition for 1992 civic
    How Do I Go About Getting The Ignition Out Of The Unit To Change With A New One Thanks...
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Mar 29, 2008, 08:51 AM
    Honda Civic Ignition Switch Replacement:

    1. Disconnect negative battery cable.
    2. Remove dashboard lower cover and knee bolster.
    3. Disconnect 5-P connector from under-dash fuse box and 7-P connector from main wire harness.
    4. Remove steering column covers.
    5. Insert key and turn it to "0".
    6. Remove two screws from switch and replace.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Where Is Ignition Module 1992 Honda Accord Ex [ 12 Answers ]

My Car Won't Start And I'm Not Getting Any Spark From The Coil, So I Replaced The Coil To No Avail. I Guess The Next Thing Is The Ignition Module.. can Anyone Please Tell Me Where It Is Located... thanks

How to change a ignition coil on a honda civic 89 model [ 1 Answers ]

How do I change an ignition coil on a hoda civic 1989 model Thanks

1992 ignition module location [ 1 Answers ]

Can anyone tell me the location of the ignition module on a 1992 Pontiac Grand Am, 4 cylinder (2.3 liter)?

1992 honda civic ignition prob [ 15 Answers ]

Hi all,seeing if anyone has any thoughts Got a 92 civic 1.5 commuter car was driving and it quit.no spark. Have no voltage at the map sensor terminals but voltage at the coil primary. Check engine light is on doesn't go off no code stored though. Did blow the 7.5 fuse under hood for ecm. Swapped...

Replacing Ignition in 1992 Honda Accord LX [ 2 Answers ]

I am trying to replace the ignition cylinder assembly in my 1992 Honda Accord LX, automatic. What is the trick to getting the old one out. I have the steering column disaasembled but I can't figure out how to actually remove the old cylinder. Any suggestios?

View more questions Search