Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Well motor -Short Cycling
[ 13 Answers ]
Old houses... great aren't they? I have a new dilema. Seems as though the well motor is beginning to short cycle during a shower or if the washer is running. I would suspect the pressure switch, however I do not know which side is the low side and which is the high side, nor do I know where to...
Amana furnace short cycling
[ 2 Answers ]
The induction motor comes on then the heat it's stay's on for two mines then cut off it short cycling all nights. Is this a bad pressue switch ,or abad board
Furnace off and on cycling
[ 1 Answers ]
We had an air bubble in the vacuum system, removed the clamp, blew in the tube, problem solved-thanks for everyone who looked!
WELL Pump is short cycling on and off
[ 3 Answers ]
I have a well pump on a 40 60 pressure switch. When a tap is open the pump kicks on and off every 30 seconds or so. The pressure tank is small probably 40gal? When the water is flowing you can watch the pressure gauge drop in pressure, and then watch as it moves up when the pump kick in for 20...
Heil furnace short cycling of burner
[ 1 Answers ]
My 1983 heil model NUGK075DG01, natural gas, forced air furnace is running but only heats the house to 67 degrees no matter how high I set the temp, the fan continuously runs (in auto on thermostat) and the burner will cycle for 3-4 min. then shut-off for 10 min.. I have powered down and back-on,... View more questions Search
|