Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Thermocouple replacement.
[ 1 Answers ]
I have a Lennox G12 furnace, about 20 years old, still working well except for the pilot light which has its off moments when it keeps going out. These seem to be periodic in that it will stay on for quite a time then start going out again for a few days, after which it works OK again. I have had...
Pilot Light goes out, thermocouple is new
[ 2 Answers ]
I replaced the thermocouple on my gas furnace last night because the pilot light wouldn't light. The furnace worked all night. This morning the pilot light went out again. What do I do now?:( :confused:
Burned out thermocouple
[ 1 Answers ]
As I had stated in a previous question I have a few minor problems with the furnace in the fourteen years we have it. This is the most annoying one. I have replaced it at least 20 times. A service man installed one that lasted only seven days. I had the gas company install one and it lasted...
Thermocouple... can you test?
[ 2 Answers ]
I had a problem with my water heater. Its only 3 years old and when it got turned back on it worked for a bit then stopped. I then couldn't get the pilot light to stay on... held for many minutes. Being uneducated in water heaters I just assumed it was the thermocouple. As I started to dissasemble...
Thermocouple Installation Question
[ 2 Answers ]
I just replaced a thermocouple using a Honeywell standard Thermocouple for a Genesis boiler and everything seems to be working fine. My concern is that I see a flame both at the end of the thermocouple and the base of the thermocouple. I own a three family and thus have three boilers one of... View more questions Search
|