Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace with Generator problem?
[ 27 Answers ]
I have a York Two-Stage Deluxe Diamond (PDU) furnace that I have recently wired to a 6 CKT transfer switch (Reliance Controls) to use with my Coleman 6250 (5000watt) gas generator. All my ckts. Work well with the generator connected, except the furnace. I switched ckts on the transfer switch-no...
Trane Gas Furnace Problem
[ 13 Answers ]
I recently experienced a problem with my heat. I have a programmable thermostat and noticed that the heat wasn't on when it was suppose to be. The temperature was set to 75 but the temperature in the room was only 68. I canceled the program and manually set the temperature again to 75. The heat...
Miller trailer furnace problem
[ 4 Answers ]
:confused: I have a Miller oil furnace in my garage that burns very dark orange and sooty. It also keeps burning inside after the unit shuts down. I have replaced the nozzle twice with no change. The flue from the top of the unit all the way through the roof is clear. Any ideas??
Furnace blower motor problem
[ 2 Answers ]
I need some help with a non-working furnace in Colorado. The furnace is an 1988 “Inter-City Products” induced draft furnace in our crawlspace. I thought I smelled a slight burning smell from a vent a day or so before the furnace stopped working. A day or so later, I noticed there was no heat. I...
New Bryant A/C compessor will not run
[ 1 Answers ]
I have a newly installed Bryant 2 1/2 ton compressor unit that was installed in August 2005. When I turned on the A/C the unit would not start. I checked the disconnect near the compressor and found it to be faulty and replaced it with a new one and there is still no start up. I pulled the panel to... View more questions Search
|