Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Pre Flame motor turns on No Spin
[ 3 Answers ]
My pre-ignition motor clicks on but will not spin. The motor spins freely by hand. Not hanging up on anything. Is the motor bad? Can I fix it myself by taking the motor apart? Could it be brushes in the motor? Please help. Thank you!
Intermittent blower on a/c only, works fine with heat
[ 2 Answers ]
I have a 1997 or 98 Coleman Natural Gas Furnace with A/C. The blower works fine during the winter when I use heat. When I use the A/C, it seems that once the blower starts working for a bit on a hot day, it evetually (if on for more than 10 minutes at a time or so) starts kicking on and off while...
Flame turns off...
[ 2 Answers ]
My heater will start but the flame will go out after a couple minutes. The fan, however, will continue to run afterwards. I just changed the thermostat to see if that was the problem and it works fine. Is this a problem with the flame sensor? I just want to make sure before I buy a new one. ...
Wireless internet works fine, but.
[ 3 Answers ]
For some reason, any computers that are connected via a cord cannot access the internet. Anybody have any ideas as to what's going on? I've checked all the cords and they're fine... internet worked perfectly last night, too.
Reset works fine, but...
[ 5 Answers ]
This Kenmore dishwasher, model 1376, works great and very quiet also. ... and then it stopped working. I suspect I might have placed something in there that blocked the spray arms. What worries me is that there wasn't/isn't any blinking light to indicate "fault" has been detected. Hope I didn't... View more questions Search
|