Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ball joints
[ 3 Answers ]
What would an estimated cost of replacing lower ball joints on my 1998 Ford F150? I called a fairly reliable repair shop this morning and they gave me an estimate of approximately $365. This would include labor and the alignment. I looked at NAPA online and found the lower ball joints at a...
Replacing sink chrome soldered gate
[ 1 Answers ]
Hi, has anyone had to change a sink gate that was soldered into a wall and had to turn the compression fit. Out of the way of a pop-up rod after changing the sink. The chrome pipe can't be heated enough to unsweat it from the copper feed.
Cold Drips in the tub
[ 1 Answers ]
My bathtub's cold water facets drips out if the knob handle when the water is running. No prob when the facet is turn off... What needs healing? Is it fatal? Should I call P-911 or are we talking plumbing 101? Thanks in advance...
Leaking drain joints
[ 13 Answers ]
I have installed a new kitchen sink, but the slip joints (brass) of the drain pipe leak, even though they have rubber gaskets and I have tightened them with a wrench. I did not use any sealing compound (pipe thread compound). Should I, or are the slip joints designed to function without such a...
Forgot To Prime Joints
[ 1 Answers ]
I remembered to prime my pvc pipe, yet forgot to prime just one of the elbows. Am I in danger of a leaky pipe now? Thank you in advance View more questions Search
|