Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Radiators not working properly
[ 7 Answers ]
I hope someone can please help. We have had problems with our heating system (2 years old) for the past 2 months and have had the people who installed it working to repair it. First the boiler stopped working properly. After a new pump, heat exchanger and circuit board were fitted, the boiler...
Old radiators + new boiler are boiling us alive
[ 6 Answers ]
Help! We recently installed a new boiler and pump in our 77-year-old home. The water pressure is great, but too much for our old boilers. They are incredibly hot and can't be turned off. Our plumber has been searching for new valves to fit to the old radiators, but without luck. Any ideas?
Water htr/heat traps/pipe config.
[ 2 Answers ]
Some time back I installed a new water heater and it had the factory installed heat traps. The instructions say you MAY have to install one or more 90° elbows in order to make a “U” configuration in the supply pipes. It also shows the pipes running vertically from the heater. I’ve read on various...
KickSpace Hot Water Heat
[ 1 Answers ]
Can anyone recommend a KickSpace Hot Water Heater. Thanks Bobby
Filling the radiators + high pressure in hot water system... => ?
[ 6 Answers ]
Okay, new house to my wife and I... we've had it less than a month and two days ago it was time to turn the heat on. This is an old hot water system, no pump (works by gravity) in a three story house. The radiator in the master bathroom wasn't full, so I tried to bleed it. Just a little air... View more questions Search
|