Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Hunter thermostat wirirng
[ 1 Answers ]
I'm trying to change my old Honeywell thermostat (which looks like T8400C) for programmable Hunter (model 44155C). Old one was connected to Hail Quiet Comfort II two stage gas furnace (on the second floor) and air conditioner (outside of the house). It has 6 wires connected to Honeywell: G (green),...
Upgrading Digital Thermostat w/ Heat Pump & Gas Aux
[ 4 Answers ]
Hi, I am looking for a recommendation for a new thermostat. I currently have an electric heat pump with gas backup and two-stage blower. The current thermostat is a very basic digital model ( White-Rodgers ) and is working properly, as far as I can tell. It works like this: Heating Mode:...
Problems upgrading programmable thermostat
[ 1 Answers ]
I'm upgrading from an "unknown" older analog thermostat to a Honeywell RTH7400 programmable for our heat. The old thermostat had only two wires hooked up, red and green. This must be a single stage unit, since we have a separate thermostat to control A/C (heat pump). The heat is a gas furnace. ...
Need Help with Hunter Thermostat Please
[ 4 Answers ]
I have a Payne PF1MNC hvac, and just replaced my White Rodgers thermostat (It wasn't blowing hot air or kicking in in Auto mode) with a Hunter 44155C. There were 4 wires attached: G to G R to Rh (with jumper) Y to Y1 W to W And an unattached B I attached them the same to the Hunter:
Upgrading to programmable ac/heating thermostat
[ 5 Answers ]
I am replacing an old thermostat for ac/heating. There are 5 wires red, white, orange, black, green. My new unit (Noma programmable thermostat). The instructions indicate points of connection using red, white, yellow, green. My confusion is, where do I connect orange and black, because there... View more questions Search
|