Tempstar 5000

erik7005 Posts: 1, Reputation: 1

New Member

Sep 15, 2007, 05:34 AM

Tempstar 5000

I have a Tempstar 5000 A/C unit and would like to know the condenser size It's model # is ca5536uka1 so should I assume it is a 3 ton unit? Thanks Erik

esquire1 Posts: 2,483, Reputation: 209

Ultra Member

Sep 15, 2007, 05:37 AM

Correct, 3T

Add your answer here.

Check out some similar questions!

Tempstar high efficiency 5000 not cooling [ 2 Answers ]

I have about a 1998 tempstar and the air conditioner just quiet. The furnace still circulates the air but it is not cool. The top discharge fan on the unit is not running it still spins if you spin it by hand. There is a electrical hum coming from some where in side the unit can't pin point where...

Tempstar Furnace [ 2 Answers ]

I have a gas Tempstar furnace , The pilot ignites but the furnace does not it tries a few times then stops. The blower works . What might the problem be?

Tempstar furnace [ 6 Answers ]

I have an 80+ tempstar with the smartvalve gas valve. During the call for heat, the inducer motor starts, but the ignitor will not come on and light. I checked the ignitor and it is good. I checked for voltage and it is good. Could the gas valve be bad, since the ignitor is controlled by the valve...

Tempstar 5000 [ 3 Answers ]

I have changed the coil because it looks like it had a spark or got hot because there was black soot on the power terminals so I replaced it but it still doesn't work. When you turn it on there is a small hum the magnets are not being pulled in, when you push them in humming gets louder from the...

High efficiency 5000 heat pump Tempstar [ 1 Answers ]

I am trying to find out if anyone out there would have any idea where I could get a wiring diaghram for a Tempstar Heat pump Called High Efficiency 5000. I believe this is a older model, and there are many out since this one. But the unit is good and I would like to use it. Any suggestions??