Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New vanity: trap won't reach wall drain stub
[ 3 Answers ]
We replaced a vanity top and sink with a new vanity top having an integrated sink. The new sink is offset horizontally about 1 inch from the old one. Turns out the old sink was at the limit for trap reach; the new one is over further still, so it seems impossible to line up the j-bend portion...
Vanity drain offset from pipes under sink
[ 1 Answers ]
I just installed a space-saver vanity where our old, larger vanity used to be. I failed to notice that the existing pipe is now not lined up with the new vanity drain. It's about 4"-6" from the top of the existing trap to the bottom of the new vanity and 4" off-center. Is there such a thing as a...
P-trap GAP - p-trap too low to meet sink drain extension
[ 13 Answers ]
I just took an old crane drexel sink off the wall and replaced it for the time being ( I want to fix the older sink) with a cheap vanity/sink set. All that was easy enough, but now to my chagrin I can't finish the job. The p trap is too low, the extension pipe from the sink doesn't go all...
Replacing single sink vanity
[ 3 Answers ]
I'm replacing my single sink vanity with a double sink vanity. Can I use the water supply lines that were for the single sink for the 2 new sinks. What do I use to supply both sinks?
No running water in one sink of double vanity
[ 8 Answers ]
Hello all. I have an original (1990) builder-grade double vanity in my master bath. One sink works perfectly, the other sink will not run water. I checked the shut-off valves under the sink, they seem fine. There was no reason for them to have been turned off anyway, I was just making sure. ... View more questions Search
|