Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Water supply for a kenmore dishwasher
[ 2 Answers ]
I purchased a new Kenmore dishwasher, (Consumer Report # 1 rated if that helps). I do not have the model number handy, however, does it normally require a hot or cold water supply? Thanks in advance
Kenmore Built-in 363 Dishwasher with Standing Water
[ 1 Answers ]
Hi, We have a Kenmore 363 Built-in Dishwasher. The dishwasher is not draining all of the way - there is a puddle of standing water (at least a cup) under the cover inlet. We only use the dishwasher once a week or so, and the standing water is growing into something rather unpleasant. We...
Recurring leaks from new dishwasher supply hoses
[ 4 Answers ]
I have just installed a dishwasher in my new kitchen. My second supply hose in 3 days has just developed a leak. The first time I thought it was a faulty hose (or the dog chewed it!). Now I am not so sure. I have attached a photo of the damage, which was identical on both hoses. The hose does loop...
Kenmore dishwasher won't heat water
[ 3 Answers ]
I have a new Kenmore Elite dishwasher. I have checked the water during the Hi Temp wash cycle and the sani rinse cycle and it isn't any hotter than 133 degrees, the temp of the water from my water heater. The instructions say the water should be at a minimum of 129 from the tap and I always run the...
Kenmore Dishwasher
[ 1 Answers ]
My dishwasher recently tripped my circuit breaker and my dishwasher was stuck in dry mode. I reset the circuit breaker and it kept getting stuck in the dry cycle. My spin device in the bottom of the dishwasher melted to the heating coil so I replaced the spinner. I then repaired the timing motor so... View more questions Search
|