Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Wiring hydro air and heat on the blower and boiler
[ 3 Answers ]
Hi , I would like to know where do I make the connection on the blower unit for my hydro air - heat, when I use a aquastat to turn on the blower to operate during the heating cycle, is this the correct way of doing this. And also were do I hook up the wires on the boiler side I`am a bit lost when...
GM Delco Heat Boiler Unit
[ 2 Answers ]
I have a old GM Delco Heat Boiler Furnace in my house, and it builds up excessive pressure, and then releases it. This happens repeatedly.
Heat runs with ac and even auto kicks on emg heat
[ 1 Answers ]
(Coleman Evcon) Some how the hot and cold on the inside thermostat switched.how is that possible?and how do I fix it?
Hotwater heat (Boiler)
[ 1 Answers ]
I have two zones heating my house,all rooms except one does not receive heat. All rooms on that one zone did not receive heat until I removed the air out of that zone my removing many buckets of water,one room at a time started to receive heat. I believe I removed all the air out of the line but no... View more questions Search
|