Ask Experts Questions for FREE Help !
Ask
    Frogx's Avatar
    Frogx Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 24, 2007, 06:37 PM
    Craftsman lawn tractor, replace gas tank
    Is there a diagram and instruction for replacing the gas tank for a Craftsman lawn tractor or a repair manual available?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
     
    #2

    Jun 24, 2007, 07:49 PM
    You might check at sears.com. Where is your fuel tank located on this model? Is it under the fender? If it is you will have to remove the steering wheel, dash, seat and fender.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman Lawn Tractor [ 3 Answers ]

How much trouble is it to change the drive belt on a 15.5hp Sears Lawn Tractor? Seems like the speed of this lawn tractor has slowed down. I am assuming that the drive belt could possibly be stretched. Any onther ideas?

Craftsman 20.0 HP lawn tractor won't move. [ 5 Answers ]

Hello, I have a 20.0 HP, 42'' mower; the engine starts and everything... it runs as long as the clutch/brake is being applied, but as you start removing the clutch/brake EVEN IN NEUTRAL the engine stops.. so the engine works but stops as you remove the clutch/Brake by the way it has a...

Craftsman 16.5 Lawn Tractor [ 1 Answers ]

I have recently replaced the mower clutch cable on my 16.5 HP Craftsman LT1000 lawn tractor with a 42" deck. After doing so, the transmission to the tractor will not engage. All the belts seem to be in place. I did not replace the clutch carriage bolt yet, as indicated by the instructions, after...

Sears Craftsman Lawn Tractor [ 4 Answers ]

I have a 10 HP Craftsman lawn tractor that will not move. The clutch works and it goes into gearbut the flat wheel spins and the gear wheel seems too have not enough pressure on it to move. Could this be just a loose drive belt? Thanks, Charlie


View more questions Search