Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Armstrong Ultra SX 80 furnace won't stay on
[ 16 Answers ]
We have a Armstrong Ultra Sx80 furnace, model GUJ050D10-3A, with a HeatCraft Control Board, cat number 70k98 (40403001). Everything fires up fine… thermostat, inducer motor/fan starts, then ignitor, gas, and the burners light, etc. After the burners are lit for 30 seconds, the blower starts to...
Armstrong ultra sx-80 furnace problems
[ 4 Answers ]
I have an armstrong ultra sx-80 gas furnace my problem is when I turn the unit on it will start up fine when I set it to heat, run for a few minutes then the flame dies. The blower stay on and will not shut off until I unplug the unit. The heat never reaches it's set point. If I wait for about 30...
Armstrong Ultra V Tech 80 furnace troubleshooting
[ 0 Answers ]
My armstrong Ultra V Tech 80 furnace suddenly doesn't want to ignite. Please bear with me as I don't know a whole lot about furnaces. I can hear and see the gas come on, but it does not ignite. I can hear a clicking noise I assume is the ignitor trying to engage, but the furnace doesn't start. It...
Armstrong ultra sx 80 furnace no pilot light
[ 3 Answers ]
We've had a problem the last 2 winters with our furnace, always fixed but last night the furnace stopped working. We checked and there was no pilot light. Actually in this model we don't even know where we would light it. Someone told me it might be the thermo couple but I am in need of another... View more questions Search
|