Ask Experts Questions for FREE Help !
Ask
    bdd28516's Avatar
    bdd28516 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 6, 2010, 01:55 PM
    Nordyne electric furnace
    I tried to install a relay to bring on my blower motor which is a good motor. However I have 24 volts that energizes the relay therefore closing the high voltage circuit going to the blower. The common leg is still going to the breaker and the speed tap is hooked to my relay. However the blower will not come on regardless of operation. What do I do?

Check out some similar questions!

Nordyne electric furnace [ 1 Answers ]

I have a Nordyne 2 stage electric furnace model E1EB-015H we changed the thermostat 3 years ago using a Honeywell RTH8500D. Since this was done we have had trouble every year. I have had Technicians out each season to work on the unit and they get it working until it is time to change from heat to...

Nordyne Gas Furnace [ 3 Answers ]

I have A Nordyne Gas furnace in my home, work up this morning to a cold house. I can't find my manual to troubleshoot the problem. Status light is blinking twice. I can get furnace to work by by-passing the pressure switch w/jumper wire. Could the problem be the Combustion blower assembly. This...

Nordyne Electric Furnace Heating Element [ 2 Answers ]

Hello, I have A Nordyne Electric Furnace- model# E2EH-012HA, and the heating element stays hot Even with thermostat in the off position, and, of course, the blower runs also with the element remaining hot. I have to turn the breaker off to stop the element from heating. Any help would be...

Nordyne furnace trouble [ 2 Answers ]

I have a Nordyne furnace, and the furnace got stuck in it's cycle. The vent blower would come on and that's it, so I had the circuit board replaced. Now, the a/c works but the furnace cycle won't even start. The light on the board just blinks twice. Any help would be great. Thanks.

Nordyne e2 electric furnace with ac [ 1 Answers ]

Hello I have an nordyne e23h012hn electric furnace, the control board is burnt and evaporator fan will not come on, replaced board and it burnt up to. The circuit on the board that burnt is the common line voltage to the fan, could it be the fan motor shorted causing this problem . Thanks chris ...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.