Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Craftsman 917.272751
[ 14 Answers ]
I have a Craftsman 917.272751 Briggs 18 OHV Intek Plus. I have it for 10 years with no problems. This year I got 2 weekend grass cuttings in until the third cutting I was 45 minutes into the 2 hour event when the tractor sputtered, ran, sputtered, ran, sputtered, like some one took the fuel line...
How do you put gear oil in the craftsman model 917.272751
[ 0 Answers ]
The rear right tire is throwing oil and I want to know how to put gear oil in my craftsman model # 917.272751. The rear end is starting to make a noise.
I have a Craftsman tractor model 917.272751.
[ 1 Answers ]
I have a Craftsman tractor model 917.272751. When I start it, it runs for about 1 minute,then starts missing and finally stalls. Sometimes it will restart, but sometimes it will not. However, after awhile, it will start again. Please advise
Nikki Carb - Return Spring Tension?
[ 1 Answers ]
Ok, so I have a small question here and looking for some advice. I am in the middle of a nikki 1bbl carb rebuild off a kohler CV25 OHV, and on the choke shaft end was a return spring coiled up around the shaft and I am wondering if there is any special tension or number of winds to use when...
Nikki carb adjustments
[ 1 Answers ]
Does anyone know how to adjust a Nikki carb on a kohler command ohv engine? I can't find any screws for this. Any help would be greatly appreciated. The engine will only run at full choke. I have ajusted the govenor. View more questions Search
|