Not your question?
Ask your question
View similar questions
Check out some similar questions!
Nordyne model E2EB-017HB
[ 2 Answers ]
Unit will not heat. Replace t stat and both magnetic contactors. Have 28 volts to red and yellow on t stat. what else can I check?
Furnace runs then shuts off too early
[ 8 Answers ]
My forced air furnace will run for around 5 minutes. Then it will stop but the servo motor will keep running. After another 5 minutes it will fire back up, the fan will kick in and it will start pushing heat. Then it will stop again some times within seconds, sometimes minutes. Does this sound like...
Furnace runs for a few seconds then gas shuts off
[ 1 Answers ]
I have an old janitrol furnace the kind you have to ligh the pilot then turn the knob for tha main burners to come on. The problems is when I light the pilot it stays lit, then I turn the knob and all the burners light up and it goes for about 10 seconds then its like you went to the gas shut off...
Nordyne e2eb-017HB blower will not stay on more than a minute
[ 6 Answers ]
Nordyne e2eb-017HB. Replaced blower motor, capacitor, both fan relays, contactor &, transformer in the inside unit. The compressor and fan outside runs. Inside blower will come on with auto set on t-stat to cool, for about a minute, then shuts off, for another 7 minutes, then comes back on. The...
My intertherm furnace pilot lights but furnace won't kick on
[ 5 Answers ]
I need some diagnostic help. We have a full propane tank. A new burner plate (last year) and the blower works. We light the pilot but the knob should pop up after one minute thus lighting the furnace. It won't pop up. What part should we replace? The furnace is a 17 year old Intertherm MGH... View more questions Search
|