Ask Experts Questions for FREE Help !
Ask
    randyrust's Avatar
    randyrust Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 6, 2009, 08:27 AM
    Toilet offset flange
    Builder installed the waste pipe about 4 inches off-center. This made it too close to a half-wall. Instead of moving the pipe, the toilet drain is partially blocked by the flooring. There is no leak but it doesn't flush solids properly. A plumber told us we would have to rip up and replace all our flooring and move the pipe. I'm wondering if an off-set flange will resolve the issue.
    hawkeye088's Avatar
    hawkeye088 Posts: 12, Reputation: 2
    New Member
    		  
    #2

    Dec 6, 2009, 08:51 AM

    An offset flange will not move the pipe. It will just move the toilet. If you just need the toilet to be away from the half wall it may be a solution for you, but if the actual waste line is blocked by flooring you have a lot more work on you hands
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #3

    Dec 6, 2009, 09:57 AM

    "4 inches off-center" off center from what? How much distance to the back and side walls exists. How long ago did he do this job, you may still have recourse with the builder.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #4

    Dec 6, 2009, 01:36 PM

    A 4" offset flange is a stretch. Could you get by with a 2" offset flange? Let me know. Tom
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Toilet Flange Offset or Replace Cast Iron Main with PVC? [ 1 Answers ]

Let me start by saying I am remodeling a small slab house in Englewood, FL. This cinder block house was built in 1950 and has a cast iron main sewer pipe under the toilet. I might add that I am not living in this house during the remodel. I am both new to remodeling and also new to this forum...

Toilet Offset Flange [ 2 Answers ]

I am replacing a toilet and need to move the waste line about 1 inch. How can I install an offset toil flange over existing one. Can I glue a new pvc offset flange into existing toilet flange / wasteline? My wasteline is 3" PVC.

Installing offset toilet flange [ 1 Answers ]

The 2x10 floor joist in right in the middle of where I want the center of the flange to be, how much of the floor joist can I legally remove so the offset flange will fit?

Offset cast iron toilet flange [ 3 Answers ]

I am remodeling an early seventies ranch built on slab. One bathroom has an offset flange of cast iron. There is only one t-bolt slot, located on the offset side. There is no place for a t-bolt on the 'close' side. The flange does not appear to be damaged, although there was a lot of rust that I...

View more questions Search