Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can a three lamp ballast be run with only one fluorescent bulb?
[ 1 Answers ]
We have a system of linear, fluorescent lights that use three bulb ballasts (we believe these are from the late 1970s). Three bulbs is way too bright for our needs, and I understand that we can't simply sub out the 15W bulbs because they must match the ballast. We have attempted to run the lights...
Occupancy sensor, fluorescent light, electronic ballast, and relay
[ 13 Answers ]
Hi! I'm at my whits end with this one so here goes... I'm currently installing recessed fluorescent T8 2-lamp fixtures in my garage, one of which I want to have powered by a Leviton PR180 occupancy sensor. After my initial installation attempt, the fixture flickered and it was then that I...
Removing ballast cover on fluorescent fixture
[ 3 Answers ]
I cannot find a way to remove the ballast cover on one of my fluorescent light fixtures. The cover is in the middle of the fixture, and there are wires coming out of the endcaps going to the lightbulbs. (Unlike other fixtures, I do not need to remove the light bulbs to access the ballast cover.) ...
Fluorescent not working - ballast and tubes are OK
[ 2 Answers ]
I have two fluorescent fixtures that are exactly the same in my kitchen. They both went out the same day - I don't know if it was exactly the same moment or not. On one of them, I noticed a tube was black on one side. I replaced the tube and that fixture works fine now. New tubes did not fix...
Fluorescent lamp vs ballast
[ 2 Answers ]
I have a fluorescent ceiling fixture with two circular lamps and two separate ballasts. One of the lamps is not longer lighting. Is there any way to determine which element (lamp or ballast) is defective? I have used a continuity tester to check out incandescent lamps but am not sure how to do... View more questions Search
|