Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Alternative to sanding drywall joints?
[ 13 Answers ]
I'm gettin' pressured to put up another wall in my basement, and my wife says she saw on diynetwork (TV show) a guy showing that you can mud the seams as you normally would, then let it dry only 1-2 hours then come back with a wet blade and skim them... instead of sanding them: No sanding...
Leaking drain joints
[ 13 Answers ]
I have installed a new kitchen sink, but the slip joints (brass) of the drain pipe leak, even though they have rubber gaskets and I have tightened them with a wrench. I did not use any sealing compound (pipe thread compound). Should I, or are the slip joints designed to function without such a...
Copper drips at soldered joints
[ 1 Answers ]
I just had the copper in my kitchen replaced by a plumber. I have been working in the kitchen... getting it ready to have the cabinets installed. I have noticed some joints drip a little bit from the soldered joints. I notice the drops on the concrete. When I touch it to check it, the drips...
Forgot To Prime Joints
[ 1 Answers ]
I remembered to prime my pvc pipe, yet forgot to prime just one of the elbows. Am I in danger of a leaky pipe now? Thank you in advance
How to work with lead joints?
[ 3 Answers ]
Hello, I am in the middle of adding a bathroom in part of my garage. What is the best way to separate lead joints in cast iron pipe? My home was built in 1957 so I don't know if they were using the hemp type stuff to seal the joints then. The pipe sort of looks galvanized to me (It cut pretty... View more questions Search
|