Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Have installed heat and cool thermostat from instructions, won't work. What can I do?
[ 2 Answers ]
Lux T10-1143SA. I installed it by the instructions, but doesn't work. Can anyone help? This is a heating and cooling thermostat
Installed the thermostat the A/C works the heat says it
[ 1 Answers ]
Installed the honeywell thermostat A/C works fine, The heat says it's on when it's on auto but fan doesn't come on unless I switch from auto to fan, at which time the fan works but only room temperature air comes through.
No Heat, New Thermostat just installed
[ 6 Answers ]
New thermostat installed, I have wired it based on the manual, 4 wires- W, are, G, why. I have done all the preset, but have no heat. I tried re-set the main breaker, and I have also checked the pilot on the furnace. Any help would be great. I have my house set at 21 C, and it is only 15 C right now
Installed Honeywell rth7400 thermostat, fan runs all the time in emergency heat
[ 6 Answers ]
I have installed a Honeywell rth7400 thermostat on my York Heat Pump. The normal heating and cooling cycles work fine, but in the "emer heat" mode, the circulating fan in the inside unit runs all the time. I have verified that the resistor elements cycle as they should and the house temp is held...
Installed new Noma thermostat 52-2570-6 heat stays on
[ 2 Answers ]
I bought this Noma thermostat and the heat stays on, no matter what. Even if I detach the front plate the heat remains on. When I reinstall the old mercury swtiched thermostat it works fine. I have a 2 wire hydronic heat system. Can anyone tell me why the heat stays on? Any advise will help.... View more questions Search
|