Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
1992 Heil 7000 furnace
[ 2 Answers ]
Last night I touch two red wires and a part fell of my furnace. I was able to put the part back on but it must be broken to come off that easy. I think it is called a flame rollout switch or sensor. Should this fall away from its location?
HEIL 7000 furnace
[ 0 Answers ]
Furnace won't stay lit iv'e tried jumping limits and roll over switches volt meter reads 24 volts what should I do could it be the gas control valve?
HEIL 7000 gas furnace with 2 questions
[ 0 Answers ]
Gas ignites stay lit till blower fan turn on then gas flames shut off. Then when calling for more heat same thing happens. Also, noticed some water/moisture in my draft inducer fan housing. Is the moisture normal since it does have hoses connected to it? Many thanks for the help. Rich
7000 Heil Furnace
[ 1 Answers ]
My Heil 7000 furnace, installed new in 1993, is leaving a wet spot on the floor just below the lower right panel edge. When I slide my finger along this lower right edge, there is accumulated water, which is dripping ever so slowly, causing the wet spot. What might be the cause of this never before...
Troubleshooting heil 7000 gas furnace
[ 1 Answers ]
On initial start up on my Heil 7000 furnace it is making one heck of a noise until the blower comes on at which time everything is normal. Heater is working perfectly at that point. Do you have any ideas? View more questions Search
|