Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bath tub spout
[ 23 Answers ]
I replaced my bath faucet and now am struggling (to say the least) to get the tub spout to not leak. It is a brand new spout that come with the faucet. A delta faucet. I cannot get the spout to not leak. I did the directions to a T and for whatever reason the spout keeps leaking through the...
Converting half bath to full bath
[ 9 Answers ]
My question refers to a half bath we are in the planning stages of converting to a full bath in the basement. Currently our basement has a half bath with toilet and sink on one half of the basement. There is then a shower on the other side of the basement with the washer and dryer, about 30 feet...
Cutting cement for plumbing 3/4 bath to full bath
[ 3 Answers ]
We are currently in the middle of changing our basement 3/4 bath into a full bath. The bathroom is 5.5' by 13.5'. We want to put the sink where the shower was and put a tub/shower where the sink was. (because the space where the shower was is too small for a tub). The old sink drain is centered 4...
Adding a bath
[ 4 Answers ]
I want to add a small bath (shower, sink, toilet) in a 2nd floor gameroom. There is a closet it can be built into but there is no plumbing nearby to connect to. Closet is on inclosed garage room wall. How does one go about this and what is an estimated cost. Thanks to all who help me out. KiKi
Gas valve noise on main valve engagement
[ 1 Answers ]
I have a carrier 58gs100ga furnace with a white rodgers 36e93 gas valve. The main gas valve solenoid chatters or rattles for a split second before it stays engaged after the pilot is proved. I just replace the spark/lock out board and the fan board for a different problem. This chatter is... View more questions Search
|