Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace stays on for 2 minutes
[ 2 Answers ]
I have a digital thermostat and my furnace seems to stay on for only 2 minutes at a time. It does this approximately every 10 min. The programmed cycle rate is 5/hr, so starting up every 10 min makes sense. If the programmed temp is 72 F and the room temp is around 72 F, it will start up as...
Buzzing sound stays on for a few minutes when Furnace starts!
[ 2 Answers ]
Hi, My gaz furnace is 2 years old and it was running smoothly last year. This year however, it started making a buzzing sound when it starts up. The sound stays for a few minutes and then stops when the heat as been blowing a few seconds. Could anyone give me advice on what this noise...
Whirlpool dryer takes several cycles to dry
[ 1 Answers ]
Here are the specs on my dryer, which is about 6 months past warranty: Type: DWSR-ELE-2406028-CV54 Serial: MR3413983 Model: LEQ9508PWO I verified that its exhaust duct and lint filter are clear of debris. Cleaning out the exhaust duct, I did notice that the lint in there was damp, but...
Furnace Pilot stays lit continuously
[ 1 Answers ]
My furnace pilot stays lit continuously Even though it states inside of the furnace and I quote "Pilot will light automatically when there is a call for heat. NOTE during thermostat off cycle main burners and PILOT flame are both extinguisehd. I have gotten many rude response that say that's...
Furnace blower cycles with Thermostat off
[ 2 Answers ]
Have Goodman Furnace built 1994. Worked fine until about 3 weeks ago. It starts cycling, and the heat icon does not show on the thermostat. I turn the thermostat off, the furnace continues to blow. Last night to verify, took the thermostat off the wall (but still had the furnace plugged in and... View more questions Search
|