Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can I use cut floor tile for a tile baseboard?
[ 4 Answers ]
Hi, I laid down 13"by13" tile for my bathroom floor, and it looks pretty good. I have enough tile left over to make a tile baseboard. The width could be anywhere from 3 inches to 6.5 inches. What would be best? Would the finish edge at the top look strange? How could I make it look best? ...
400 amp service with 2-200 amp panels & 320 amp socket
[ 6 Answers ]
Hi TK. I am running 400 amp service into my new contruction home. The electric compnay is running a single 400 amp line to the meter. I have to split it to the two panels at that point. You had told me once before that I need a 320 amp meter socket and then run 2-200 amp lines to the separate...
Tile & Cultured Marble
[ 2 Answers ]
Can one rough up and tile right over 1/4" Cultured Marble wall panels?
Cutting tile curves in fron of tub
[ 2 Answers ]
What's the best way to cut porcelain tiles for the curved area along the front of the tub. I will be using 12 x 12 porcelain tiles. I was thinking I could use my angle grinded with diamond blade to get the basic shape then use tile knippers to finish it but I have a feeling it's not going to be a...
Shower doors & deco tile
[ 2 Answers ]
:confused: I'm installing a bypass (2 sliding doors) bath and shower door on a 5ft tub. Problem is that I have decorative tile molding wrapping the entire bathroom including the bath tub enclosure, and the deco molding sticks out (not flush with wall tile) about 1/4 inch so the side rails (wall... View more questions Search
|