Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Wiring codes from old Carrier thermostat to new Hunter thermostat
[ 1 Answers ]
WIRING CODE HELP FOR THERMOSTAT I am in an office and have an old Carrier programmable thermostat which no longer works. I purchased a Hunter 44660 thermostat to replace. My problem is that the wiring codes on the previous thermostat do not match up the codes on the new thermostat. Codes and...
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
Outdoor wiring system
[ 1 Answers ]
I wish to light a trail 400' long. It will require 6 100watt lights and the ability to support a small 450-750 watt heater at the end of the run. I of course want to do this in the most economical fashion. I'm a doit yourselver and do not intend to have it inspected. I intend to do an areial...
Honeywell wiring different from old thermostat wiring
[ 2 Answers ]
I purchased a non-programmable digital thermostat to replace an analog thermostat with wiring red, white yellow and black. How do I match the wiring? HELP!!
Wiring a 2 wire thermostat to a 4 wire system
[ 1 Answers ]
I have a gas furnace equipped with central air.The compressor is shot in the AC unit,and I needed to replace the thermostat so I bought a heating only thermostat.I have the blower and the w wires together on the w terminal designation and the rh on the r terminal designation, and I have the y wire... View more questions Search
|