Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Cast iron shower drain in concrete floor-replacement
[ 7 Answers ]
Hello. This is my first post here and I'd appreciate any help you can provide. I have a tiled shower on a concrete slab. The drain is cast iron... sort of a bowl-shaped 3" dia. opening with a lead seal to a 2"-2 1/4" cast iron pipe. In removing the old "Premier" pull-up drain stopper, the brass...
Rotating Toilet 90 degrees on Cast Iron Flange
[ 1 Answers ]
I am remodeling a bathroom in a 60s vintage home with adequated crawl space. I need to rotate the toilet flange 90 degrees to install the new toilet as the orientation has changed with the remodel. The materials of construction for plumbing is cast iron. I am keeping the same elevation of floor....
Toilet flange on concrete
[ 3 Answers ]
I saw this addressed in another thread, but my question has a twist. When my house was built (bi-level) the lower level was unfinished but I had them rough in plumbing for a 3rd bathroom. I have completed the other rooms, and am now ready to tackle the bathroom. The supply lines are fine, the...
Cast Iron Toilet Flange Problems
[ 3 Answers ]
Hi, I have read forums on having the cast iron toilet flange being too high after tile removal. I have some additional questions on this: 1. After removing the Thick set Mortar, the flange is 1 " above the subfloor. Can I just add different types of underlayment to reach the flange (i.e....
Remove cast iron flange
[ 2 Answers ]
I am replacing a plastic (fiberglass?) shower pan with a new one. I have the existing pan free from the walls and subfloor, but it is still being held in place by the drain flange (I did remove the strainer!). The flange appears to be cast iron (it is very rusted inside) and is about 4 inches... View more questions Search
|