Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do you wire a 3 way switch - black screw connected to white wire is this right?
[ 28 Answers ]
I have a 3 way switch I am replacing. It has 4 wires coming out of the outlet. The top two terminals I am going to wire Red left and Black right. The bottom two terminals will be ground left and white right on the black screw terminal. This does not seem right, but an electrician said it is...
Connecting a #14 stranded wire to a #8 screw terminal
[ 4 Answers ]
What are 5 products that could be used to connect a #14 stranded wire to a #8 screw terminal?
Why was the Blue wire connected to a blank screw?
[ 5 Answers ]
Hi. I just replaced my old mercury thermostat with a Honeywell RTH2310. The old wires were : yellow connected to a "Y" screw, Green connected to a "G" screw, White connected to a "W" screw, red wire connected to "Rh" screw and a Blue wire was connected to a blank screw, but was right next to an...
Yikes! Does the blue thermostat wire go to the C terminal?
[ 11 Answers ]
Hi. I'm trying to install a Honeywell RTH7600 programmable thermostat. I've detached my old thermostat, and I'm trying to figure out how to match up the wires. It's heat and air conditioning, and the old thermostat was a pretty basic, older round variety (also honeywell). Problem is that I...
12-gauge wire will not fit in 20A outlet screw terminal
[ 10 Answers ]
I have run conduit which came with 3-wire 12 gauge standed cable. I have it going to a 20A outlet, but all of the strands will not fit in the screw terminal. The breaker is a 15A. Can I trim a few of the 12 gauge strands to get the wire to fit onto the screw terminal? Are electrical outlets also... View more questions Search
|