Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Best way to cap a copper water line: compression fitting or copper cap?
[ 29 Answers ]
Hi all, Unsuccessfully tried to cap a copper water line by soldering a pre-soldered cap onto the end. Took all the proper steps, cleaned the ends of the pipe and fitting first, then applied flux around both. Wasn't quite sure what I should be heating, so I just heated everything. After my first...
Tips on copper compression fitting?
[ 11 Answers ]
My problem is whenever I work with coppoer compression fittings, I never seem to get a good seal and something always leaks. Are there any tips on how to do it right? Should I use a hack saw verse my Reciprocating Saw to cut the tube? (SLow vs Fast). I know the cut has to be straight, then...
Leaky copper joint fitting
[ 5 Answers ]
I am not a plumber, but I soldered a T-tting into a ½" copper pipe, using a propane torch. I used flux (which was 10 years old, does it expire?) but unfortunately, it has a slight leak because apparently not enough solder got into one of the joints. Then I tried to touch up by adding more solder,...
Reorienting a copper fitting
[ 14 Answers ]
I have 3/4" copper water supply line that enters my house through the basement wall, makes a 90-degree turn and runs for a short distance horizontally, makes another 90 and goes vertical for a short distance, then through another 90 to horizontal where it goes through a pressure reducing regulator...
Copper Pipe Compression Fitting
[ 7 Answers ]
I'm installing a dishwasher, I've never had one before so I am making all new pipe connections. I'm trying to add a t-fitting and then a valve to a copper water line to be able to turn off the dishwasher water supply while still being able to use the sink. I was told a T-compression would work. ... View more questions Search
|