Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Mixing valve problem
[ 1 Answers ]
My shower mixing valve was fine when installed, but now I can't seem to get enough hot water.(rest of the house is fine) When I turn the valve all the way to hot it will get a little hotter but then I lose water pressure. It is a moen and there is only a shower unit. No tub. Thanks shulta44
New mixing valve doesn't entirely divert water
[ 1 Answers ]
I just had a new tub/shower mixing valve installed and noticed that I can't get the flow to be 100% shower, there is always some flow coming out of the tub spout. Is there something that can be adjusted with the diverter valve to correct this?
1 valve shut off hot water tank valve
[ 9 Answers ]
I was just trying to get some Pro's thoughts on, why there would be a shut off valve on the hot line going out of my hot water tank, and no valve on the cold coming in? Is there a reason for this? Is it OK to add a valve on the cold,so I can isolate the tank, by shuting both valves , and would...
Difference between steam valve and hot water valve
[ 1 Answers ]
We are in the process of changing our small steam heated library to hot water heating on an extremely limited budget. Three of the existing zones are not presently being used but our heating engineer suggests changing out the existing pneumatic actuated steam valves to pneumatic actuated hot water...
Water Circulates Through Mixing Valve
[ 2 Answers ]
I've installed a Kohler Thermostatic Mixing Valve with Volume Control (K-404) in my shower construction project and just noticed that the hot water is circulating up through the valve and then back down the cold pipe! Yikes- this puts water from the hot water heater into the drinking water and... View more questions Search
|