Search:
Type: Posts; User: jh10863
Search:
Search took 0.00 seconds.
-
Sorry about the pic.It's a 2 in vent with a vanity connected to it downstairs with a 1 1/2 trap about 2' away and upstairs the tub may or may not be connected to the vent. It could be connected to a...
-
Hello,I would like to move my washer upstairs could someone tell me the best way to run the drain.not sure if the tub is running to the 2 inch vent because its under the floor under the tub. Iv'e...
-
The rest of the quote was "If in good condition".
-
Any linolium flooring made after 1979 probably does not have an asbestos which was not made ito it but used as a backing. I think would be safer to leave well enough alone and cover over it, if it is...
-
I also laid 12x12 tile over linoleum using thinset 5 years ago with no problems in kitchen and bath.Just this week I removed the tiles in the bath,half on linoleum the other half on the slab and...
-
Actually that e-mail was sent before you answered me in the forum,even before my last post,sorry for the misunderstanding.anyway I'm closing that long run and ran a new vent behind the new toilet to...
-
I was not asking fitting by fitting instructions.I just wanted to know if the vent would work.You ask me to draw the lavatory in Aug,5th and I did.Ireposted Aug 8th still no answer.This last post Aug...
-
Thank you very much for a quick reply,didn't mean to pressure but wife is getting quite voicey about the holes in the master bath floor
-
Seems like my questions never get followed through,here is a link to a link for original post please advise me on how to proceed...
-
Here is the original post https://www.askmehelpdesk.com/plumbing/tying-into-waste-line-under-slab-116509.html
-
-
The drain for the shower Im installing sits almost directly above the 3 in main,what is the best way to trap it.Can the wye sit vertical and the trap go beside the waste line a little above it like...
-
Hello all'
I'm installing a plastic shower base with an oakley caulkless shower drain to a 2 in pvc pipe cut even with the slab.the problem I'm having is the rubber caulking gasket slide out of the...
-
I was trying to glue a 3 in pvc tee and could not make the connection.I immediately wiped off the glue from both ends without joining them, can I reuse the tee?
-
I will have a trap going straight down to the waste line from the shower there is a vent in the 3 inch main 3 ft up stream,will that vent properly.Also where the new toilet sits I used a long radius...
-
Originally there was a tub with drain and water through the slab where the lavatory is now.I don't know how or even if there was a vent there, when I put the lavatory in, the water drained slow so I...
-
Thanks Tom,that's exactly what I needed to know,the guys at the big home store said there was no part to do it with without cutting out half the foundation.
Next question,where is the best place to...
-
Hello I'm tying a 3 inch horizonal ABS into an existing 3 inch horizonal ABS line at a 90 degree angle under a 4 inch slab.the main line will not move,is there a special y fitting to make the...
|