Search:
Type: Posts; User: jeremu
Search:
Search took 0.00 seconds.
-
Thank you!!
I'll replace it and tell you what happened.
Hopefully I can start getting some sleep at night... am I the only one whose wife waits till you are almost asleep to start telling you...
-
I wanted to remove the handle cause I want to replace the faucet. One bathroom is leaking all the time and my shower leaks hot water when it's turned on.
I figured since I'm going to replace it I...
-
You are so right... A word of caution
Make sure you unscrew the screw all the way (make sure it falls out)
Also there is a snap ring in the front holding the plastic plastic piece on. It might be...
-
I have an old Kenmore 80 Washer and 9 times out of 10 it gets stuck in the wash cycle.
It will go on for hours if we don't stop it and turn it knob manually.
Regular, permanent press and...
-
Yes it's the top one with the MRM-MET.
I got it off this weekend. SCORE!
I sprayed some penetrating oil in it and then banged it a little with the back of the screw driver then twisted and...
-
Is this cause it's pressed on there?
-
I have a Mixet faucet and am attempting to get the Volume Control Handle off. I unscrewed the screw in the front. I could not get the handle off by hand. I took the back of the screwdriver and beat...
-
I thought I would mention I just replaced a leaking water pump last week. I don't know if the water pump broke cause of the clog, but just wanted to mention it.
-
I figured it out! The drain hose was clogged.
I removed the drain hose... I know this next part is gross... then I put my mouth on the end and blew. I felt a little resistance so I got a small...
-
Kenmore 80 Series Washer
Model: 110.82881810
After my washing machine is done the clothes are still wet and there is a puddle of water at the bottom of the basket.
I filled the washer with...
-
I also wanted to say that I did replace the Water Inlet Valve (WIV) and just happened to see the warped connector while installing it.
SO there is a possibility that the WIV was also bad, but I...
-
You're RIGHT!!
There is a little purple wire connected to the water level switch that was corroded and all green (like oxidized copper.) Also the connector for the purple wire looked like it was...
-
I broke down and bought the valve.
There is a no return policy for any electrical part so lets hope it works.
Kenmore 80 Series Washer
Model: 110.82881810
Part: Water inlet valve
No. 285805...
-
I have an old Kenmore 80 Washer and nothing works, but the spin-cycle.
Many posts say that it's the Water inlet valve, but I don't want to spend $30-$40 to change it if it's not the right part.
...
|