Search:
Type: Posts; User: Neos
Search:
Search took 0.00 seconds.
-
Yes. There is a thermostat that prevents the dryer from getting too hot, baking your clothes. Not sure if it cuts it off entirely - may just regulate the current. Your checking it outside it's...
-
Not quite sure. First impression is that it is in the electronic control panel - probably pretty pricey.
It might be worth checking your plug and make sure you are getting 115 on each side (but this...
-
-
I saw that in the junkyard the other day. I have a 760 turbo so my setup is different.
It definitely won't run with that hose missing. There is an idle control valve below the intake manifold -...
-
You did not say which Volvo. Is it a 240, 740... etc. Probably is one of those - so there is a 700/900 series faq @ The Volvo Resource: brickboard.com. Just use the dropbox where it says 'select...
-
Not sure - but go to The Volvo Resource: brickboard.com. Set up a user name and ask in the FWD section. Someone there will know for sure.
-
You are blessed that it did go down the drain mostly. I had this happen with a Speed Queen when I lived in an upstairs apt. after I went to bed - cost me a lot of money for the water damage below me....
-
When you pull the front to replace the belt - take a look at the slides on the front. Also check the wheels at the back where the drum rides, and any wheels that the belt may make contact with, like...
-
We had been told that the problems you mentioned had been corrected. I guess I am looking for a time line so as not to buy a pig in a poke.
I am pretty handy, but do have other options (an...
-
The dryer getting too hot is something that we have recently experienced on an old Hotpoint dryer. It has a bad auto thermostat in the return, so if it gets too hot on the auto dry cycle - it stops...
-
Make sure first you do not have a badly out of balance load. The knocking usually is the tub hitting the sides.
You might try to spin it with just a load of water. If it is OK with just water, and...
-
You mean the agitator does not rotate, right? If it was working prior to replacing belts, then you need to double check the belt - probably the longer one. The smaller if I recall - goes to the pump,...
-
Are yours the Maytag brand? Have you had a prob with mildew. I do understand that if the boot around the door is kept clean there will be no problem with that. Has that been your experience?
Thanks...
-
This happened to me years back. I left the washer on as I went to bed. Bad move! I woke in the middle of the night to find a flood.
The water level control was misbehaving. I replaced the control...
-
Are you saying that because of the way they clean, or because of the problems I listed - possibly others. Also does this apply only to the Maytag, or all front loaders - in your opinion?
Thanks for...
-
Check your drain and make sure that it is completely clear.
-
Does it agitate? If it does not agitate or spin, you probably have a belt problem. The belt should be under the base of the washer.
-
I have a chance to get a pair of Maytag front load laundry (new) for a really great price (less than 1K for both), but I am a bit cautious as I know there were issues with mildew in the boot, and...
|