Search:
Type: Posts; User: bandb
Search:
Search took 0.00 seconds.
-
No it run a few minutes and shut down then the fan kicked on a few times it just wouldn't heat
-
What kind of units do you all have
-
So if there was much larger flames then it would have been burning hotter which probably would have messed up the limit switch right?
-
Make sure your t stat is working properly it could be going bad sometimes calling for heat and sometimes not I've learned most the time it something simple hope this helps
-
Did it specify that it was the pressure switch
-
We thank you for all you all do
-
Hey I'm not for certain about the laws where your at but I think you have the right to withhold rent till it is fixed
-
Hey I'm not for certain about the laws where your at but I think you have the right to withhold rent till it is fixed
-
Hey this is leslie can someone please tell me if you forget to convert a reem gas pack from natural to lp and start the unit will it damage any of the componets or will the safety features just shut...
-
Thanks for all your help. You know what it ended up being? t-stat.guess I should have been thinking more simple lol.
-
OK before reading yours I put uld board back on inducer motor came on so your righ about the board is there any way to check pressure switch or jumper it
-
It was wired the same way it came off I done them one at a time if that pressure switch is bad would it cause it to have less operation after replacing the board then it had before the board was...
-
We changed the gas valve and rollout switch neither one of these made a difference changed the control board and now the inducer motor won't even come on how likely is it that the pressure switch is...
-
Does not have led light we replaced the gas valve that was not it replaced rollout switch nope not that either replaced control board now nothing there were serveral burnt spots on the board could...
-
What is the most likely cause of this inducer motor comes on but unit won't ignite model #pgaa36d1k3
|