Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: frankyie

Search: Search took 0.00 seconds.

  1. Question: Drop-eared elbow

    by frankyie
    Answers
    2
    Views
    5,597

    Drop-eared elbow

    How far behind the finished wall should I install the drop-eared elbow for the shower head? See the picture
    Any problems if is 1.5" behind ?

    Thanks
  2. Answers
    1
    Views
    2,177

    Toilet bowl - pinhole leak

    Hi,

    I just changed a toilet bowl due to a pinhole leak - the water level drops overnight.
    I 've learnt my lesson so I installed the second toilet bowl in my garage on a flat surface, slowly...
  3. Answers
    2
    Views
    2,590

    Hi Tom, Thanks for your reply. Is about 1/2 "...

    Hi Tom,

    Thanks for your reply. Is about 1/2 " below the tile.

    Regards from Frank
  4. Answers
    2
    Views
    2,590

    Waxless ring and flange extender

    I am almost done tiling the bathroom floor and the old flange sits underneath the finished floor..
    If I use a waxless ring like the one in the picture do I still need to add a 1/4" flange extender...
  5. Kitchen sink relocation- Drain and vent question

    Hi,

    I want to relocate the sink to the opposite wall. This is about 10' from the current location. Can I just extend the drain pipe under the floor from old to the new location ? I am not quite...
  6. Answers
    3
    Views
    7,314

    Hi Tom, I replaced the picture in the previous...

    Hi Tom,

    I replaced the picture in the previous post. With yellow line is how the old p trap was attached to the drain pipe using a 90 elbow.

    With red is how I want to connect the new 2" p trap...
  7. Answers
    3
    Views
    7,314

    Shower P-trap question

    Hi,

    Should the 2 pieces of the shower p trap be in the same plan ? In order to align the p trap with the 2" drain pipe I will need a 135 angle between them. I'd like if possible to avoid one of...
  8. Answers
    3
    Views
    1,596

    Thank you Tom ! Just to make sure I am on the...

    Thank you Tom !

    Just to make sure I am on the same page with you:

    1. cut at the base of 1 1/2". That will give me about 3/4" room to work with
    2. clamp the remaining 3/4" of pipe to the left...
  9. Answers
    3
    Views
    1,596

    3x3x2 abs wye question

    Hi,

    I want to upgrade a bathtub drain from 1 1/2 to 2" because I am replacing it with a shower.
    I dug a trench all the way to the 3" horizontal stack and found that I can cap the old 1 1/2 pipe...
Results 1 to 9 of 9