Search:
Type: Posts; User: zeusters
Search:
Search took 0.00 seconds.
-
-
Thank you. I can do that.
-
Old GE hood vent. The push button light switch is broken. Had two on settings dim and bright. Pulled the switch and it has three wires. Blue Black and Orange. Local hardware store just has a...
-
I hooked the blue to the Y. New thermostat works well. Thanks for your help. I was reluctant to open the furnace because Landlords live next door, I have to go outside and through a cellar door to...
-
I pulled the plate off the wall and there are just 4 wires(bundled) coming out of the wall. The blue comes out of the wall and not the yellow. The yellow wire that is connected to the yellow screw...
-
I'm replacing a old thermostat with a new digital Honeywell one. On the old one both the Yellow and Blue wires are connected to the Y screw. I also have a green, red, and white. The new ones...
-
That looks like what I need but it creates a bootable disk. I do not have a floppy drive. Do you know if it's possible to make a bootable cd from something like this? I know how to burn a iso file...
-
I can not find any bios version to download except the latest.
-
HPSupport says it's out of warranty. Take it to an authorized dealer. Big help they were.
-
I'm using a later bios than discussed there. The download is a later version and the later version shows up in the system info.
It's F.24 . Wish I could find the version listed there. Might...
-
It has the most limited bios settings that I have seen. There is no option to enable LBA mode. Can't figure out how it must have had a bigger hard drive at one time and now will only see small ones.
-
I have a used Compaq EVO n800v. I can install and run Windows 2000 on two different 6gb hard drives. When I try to install on a 30 and a 40gb hard drive the installation cd sees the whole 30 or...
-
Thanks. The nut is off but the basket is still stuck. I'll try tapping it up from the bottom.
-
We were moving a old cast iron utility tub and needed to replace the drain pipes. When trying to loosen the nut locking the basket to the tub the pipe broke at the top of the locking nut, flush with...
-
Thanks, I'll give it a try today.
-
I am installing 5 1/4 inch baseboards. I have only mitered using boards standing and my saw will not cut this tall. I have access to a 10 inch compound miter saw that says will cut 6 inch...
-
-
I'm getting ready to tile a small bathroom floor. Is the premixed thin set as good as mixing the powder up? Thanks
-
Thanks, I'll give it a try!
-
One of our toilets barely flushes. It's not the flapper type of insides it's a mansfield toilet and the kind of insides that slide up and down to cover the drain hole. The tank fills full but when...
-
Thanks for the quick response. So do I screw through the tile and cement board or don't have them under the flange just having the flange raised to the height of the tile? Thanks again... this is...
-
After reading different post I'm not clear what to secure a new toilet flange to. I had to replace the subfloor and I am getting ready to put down 1/2 inch cement board and then new tile. Would you...
|