Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: hoseb2000

Search: Search took 0.00 seconds.

  1. Normally a heat pump stat will bring on the aux...

    Normally a heat pump stat will bring on the aux heat if the temperature increase is higher then 2 degrees about ambient temperature:D
  2. Answers
    8
    Views
    2,039

    When do you have 25volts at the gas valve. You...

    When do you have 25volts at the gas valve. You should only have it for a short time after the ignighter glows and no flame is detected . Check to see if you have condensate in the furnace trap. You...
  3. Answers
    2
    Views
    485

    It sounds like you have a heat pump and your new...

    It sounds like you have a heat pump and your new t-stat is not a heat pump stat. Is this possible?
  4. Answers
    4
    Views
    6,150

    Advertising:eek:

    Advertising:eek:
  5. Answers
    4
    Views
    3,622

    It is also possible that the circuit breaker is...

    It is also possible that the circuit breaker is weak and tripping due to that issue or the wires at the breaker are loose and overheating the breaker .
  6. I install a lot of Goodman equipment and for some...

    I install a lot of Goodman equipment and for some unknown reason this year I replaced a lot of compressor contactors in these units. Your unit should have at least a 5 yr. parts warranty through...
  7. Answers
    2
    Views
    980

    Make sure your air filter is clean. A dirty air...

    Make sure your air filter is clean. A dirty air filter will cause unit to ice up:eek:
  8. Answers
    9
    Views
    1,460

    White -W Yellow-Y Green-G Red- R/C & R/H (...

    White -W
    Yellow-Y
    Green-G
    Red- R/C & R/H ( need to install jumper)
    Blue- Isolate
    J2-HG

    It does not appear that you have a heat pump but a gas heater and no electric heat
  9. Answers
    9
    Views
    1,460

    I think your problem is the blue wire should not...

    I think your problem is the blue wire should not be on the RC terminal, you need to put a jumper across the RH to RC and if your t-stat does not have a C terminal then isolate the blue wire. You are...
Results 1 to 9 of 9