Search:
Type: Posts; User: PeterHD13
Search:
Search took 0.00 seconds.
-
I had this problem with my 1990FLTCU. On deceleration the front wheel began an increasingly violent side to side movement. At first I put it down to the front wheel only being 16 inches in diameter...
-
Have you checked the adjustment at the clutch removing the derby cover. If the adjuster is too far out the clutch rod won't engage with enough length to separate the plates. Missing clutch rod parts...
-
I've got a 1990 FLTCU and it does the same thing , when it's cold. I found the Evo aluminum motor takes a fair while to properly warm up. Until the engine has warmed and the aluminum has expanded to...
-
Sticking throttles can be very dangerous especially on the road. Make sure it's not just your idle screw setting to high first as when bikes warm up they can idle faster. Check your cables are free...
-
If this is a cable operated clutch there is supposed to be about a quarter of an inch or more free play at the handle. You can get a way with a bit less but as the bike heats up this free play can...
-
I heard about this years ago back in the late 70's a bloke had a CBX and left the fuel on when he stopped it the fuel kept getting sucked into the cylinder went past the rings and into the sump and...
-
Definety sounds like a circuit breaker are the cables connected correctly copper stud has the right cable/s . I've got six under my dash on my 1990 FLTCU. Then there's the starter relay and...
-
Check your rear wheel is balanced. Also check that the alignment is good, straight check visually that the wheel is pointing straight. Check your rear shocks are OK they can go blow seals. Check air...
-
Yeah a lot of times it can be a coil but check the connections are clean first undo the nuts on the coil and clean the terminal ends and electrical contacts. Also check and clean inside the High...
-
If your oil level goes up after the bike runs for a while it could be expansion of the oil due to heat. But if your bike is a dry sump like my 1990 FLTCU the models before the twin cams it might be...
-
I've got a Harley-Davidson FLTCU 1990. I want to know the procedure for removing the radio/cassette and caddy from the frame mounted fairing. Also the size the nut on the central bolt which is...
-
No . When you say making oil is it leaking somewhere specific?
-
I've got a 1990 FLTCU, Dry SUMP. The crankcase breather which used to run to the ground now runs up a chrome pipe to the airfilter because of Environment Protection Agency. The oil is supposed to...
-
Check your throw out on late models 1989 on (Electro Magnetic) the copper ring gets covered in muck , black stuff so does the contacts it hits which transfer current through the ring to the starter...
-
Hi
I've just installed a custom chrome 5 speed kicker in my 1990 FLT Harley Davidson. It kicks in one to 4 kicks when dead cold full choke ( stopped for 2 days) but when it's hot it is hit and...
|