Search:

I have seen on two units this winter, same model, where your pressure switch hose connects to draft inducer housing, restricted. Pull hose off and run paper clip in port a couple of times, and...

You didn't get this from me 1-800-756-2926 maytag tech line use this acct, tell them you can't find your acct #

Might need water valve, check screens in hoses first and in the valve , where the hoses screw on

Stuck electronic damper, probably will need to call for service, something you do not want to guess at , could get expensive

You have sealed burners I would assume, don't lift top, take screws out of burners, then lift top. You will need to replace the gas lines you broke, sometimes comes in assembly, just not a line

Is this a matching pair to a front load washer

Pop the top from the front use putting knife to press in catches , hinge top up, remove to screws in front panel, slide panel downward.

Thermistor failure, little round black device on the back of dryer, you need to remove the panel to get to it.

Does this dryer have a touchpad test , this will light up all buttons on touch pad.

If this is the stove I am thinking about , couple years old, their was several service bulletins on the burner design and spark module board and also need electrical noise filters

Your switching from 4 to 3

Take the bottom panel off, three screws usually metric or torx, and the tech sheet is on the left in envelope, that might help

Check your amp ratings verus the wire size and breaker

You will need a defrost drain heater, take a piece of bare solid copper wire, 14 gauge works great, wrap it around the defrost heater and then insert in the drain about two inches, let me know if...

If this is an electric dryer it will probably need a new thermal fuse , located the on the back of the dryer neat the exhaust vent, you will have to take the panel off to see it. It is white and...

If possible you need a zoning system installed, aprilaire makes nice setup

Very dangerous

I would say if it has been working fine for a while, you don't need to adust it, replace it with a new millivolt thermostat gold contacts are better

What controls the valve

Its hard to say, could be vavle. I would start at would contols the vavle, thermostat, control board, don't think zebras

First of the year goodman now offers 10 year warranty on all the products standard, ps you can generally 10 yr labor cheap too. I am a goodman dealer

I have also , bided any 80% with liner, I think the prices are fair, I would go with the company that brought up the liner issue. I have seen a lot of companies not even bring it up. The water...

Is this a heat pump

What's the serial # on this 80%eff 75,000 BTU furnace

p.s. I had some zoning in a house, the new thermostat had also be wired this way, even though the old one did not. Honeywell zoning

With the information given I would say you have a stuck sequencer ( Thermal time delay)

Thanks for the help, found problem. It was just on one circuit. Kind of hard to track in a mobile home when it was at least one fixture in every room. Found neutral on a outlet that had a bad...

When I say half the house, I did amp checks on all the breakers and three out of the eight 120vac breakers are not pulling any amps. Inside the panel every breaker has 120 vac coming out, I pretty...

Half of the house, has no power. I checked everything I thought it was, but not having any luck. I checked boxes where the power is not working for loose neutral, nothing. I have checked for lost leg...