Search:
Type: Posts; User: tmeyer01
Search:
Search took 0.01 seconds.
-
This started about a year ago. Used to work fine. Typically when my furnace reached temperature the heat and blower would shut off until next cycle of heating.
Now it starts the same but the heat...
-
Hi, I have tried to trace these two small wires that come out of this thing attached to my light fixture but can't figure it out. They go into the ceiling unseen so not sure what they are for.
Can...
-
Hi, I'm about to install a water softener. I know it needs to be connected between the outside water and the house water lines but someone decided to connect those two lines in an additional location...
-
Sorry, yes I know I don't want the outside faucets going through the softener but the way they did this makes it more work to have that happen.
The red is the main water line coming into the...
-
Hi, I am about to install a water softener which connects between the sillcock line and the rest of the house and water heater. For some reason those two lines were connected further down the supply....
-
I have an MTD 2 stage snowblower. I recently had to replace the worm gear but now it works fine. This last time I started it it was really loud compared to what it normally is. Seemed to get even...
-
Another question on this. Is there a problem using 2 sections of tubing and joining them or do I need 1 continuous section of tubing? I need about 40 feet and was wanting to use 2 20 foot sections...
-
Yes I will hire someone to hook up the lines but I just wanted to know where to run the line for them to hook up. Thanks
Yep I am aware of all of that too. I just wanted to know where to run the...
-
I’m adding a garage heater. Can the natural gas line be tied into an existing gas line (T joint) or does it need to run back to the steel pipe where the other gas lines originate?
-
Yep I have some.
I can get flame shooting at the plug when out of the engine and turning over (I know, dangerous) but then nothing when I put back in the engine after spraying in there. Very...
-
It is like it is getting spark until I put it back in the engine and then not?I say it has spark because if I take it out but leave the plug wire on, put it next to the frame, and turn it over, there...
-
Hi, I have a Chinese brand ATV (Coolster). It's only a couple years old and barely used. It was running well but then just could not get started one day. I have replaced the carburetor with a new...
-
Thanks. I have tried running directly from the adapter, brand new harness, right to some brand new tail lights and ground to trailer frame and still same outcome. I took all other connections and...
-
So I have tried everything. Even bought all new brand new lights, wires, etc. I have the tail lights and turn signals working but the brake actually turns the lights off? What could be causing this?...
-
Well after trying every combination I determined the fridge just doesn't work. Thought it was the rat's nest of wires but every combination and messing around with other things didn't help. I was...
-
I figured it out but thanks for the replies.
-
I recently purchased a 1990 Starcraft pop up but the lights and fridge don't work. All the wires have been cut an re-spliced so not sure what should go where.
I have the main 120v running into the...
-
Hi, Does anyone know anything about these? I have searched and searched and can't find much of anything about this musical instrument. There are a lot of autoharps or zithers out there. Most of them...
-
Thanks for the reply but it's not the tires or the driving. I'm positive of that. I have quite a bit of winter experience myself and know how to drive.
I have slippage on that one side even on...
-
Hi, I have a 05' Town and Country Minivan which I really can't take anywhere in winter anymore without getting stuck. Even on almost flat surfaces. I noticed a while back whenever my front tires were...
-
Ok, from what I have been told since it worked intermittently, it was not the resistor. I took the blower motor out today and tested it right to the battery and it worked fine. This is an automatic,...
-
-
The A/C and heat work fine. The rear blower works fine. The front blower does not. Sometimes it runs when I start and sometimes it comes on as I'm driving. Lately it hasn't come on at all. I have...
-
-
I will be doing it myself. Just to clarify:
1. I should put a 2" cleanout on the sink drain and then vent that out with at least 1 1/2"
2. Don't really need a cleanout on the shower drain vent but...
-
Can someoe please verify what all the pipes are? I know the toilet and I assume the one right behind it is a vent. I'm pretty sure on the sink drain and the shower drain but what is the pipe next to...
-
Hello, hoping someone can tell me my issue by knowing the situation. I assume it's a resistor or motor problem but not sure. Two nights ago I drove the vehicle and everything worked fine. Yesterday...
-
Hello, I have a SUNL Transformer V6 ATV. (China youth ATV) It was running just fine but I lost the only key for it. I thought I would try to hotwire it somehow but apparently I did something wrong....
-
I have a Chinese youth ATV. It worked fine earlier this year but then the battery was removed. I now have a new battery, I have filled the tank with new gas, and I have spark. If I spray gas directly...
-
No, there are no apparent leaks anywhere. The first can of coolant I put in had some neon colorant in it. You can certainly see what sprayed out from hooking it up on the port but I see nothing...
-
I have a 2000 Tahoe. The air worked earlier this spring but then just stopped getting cold. I added one can of coolant but it didn't seem to help. It had a colorant in the can to help find leaks but...
-
I have had a knocking sound when I start, stop, or go slow. The tires, brakes, and rotors are OK. I had no movement at all on the passenger side when I removed that one. When I got to removing the...
-
Yes, I have taken the entire dryer apart several times. The entire body and duct work. I had to when I replaced the motor. It has all been cleaned. There are no air restrictions but still stops.
-
Kenmore
Model 110.66822694
Serial MJ2060676
-
The motor burned out on my Kenmore electric dryer a few months ago so I replaced it. In the process, I burned out the thermostat which I then replaced. It worked great for a couple months but...
-
No lanyard. Just a kill switch by the throttle. The only thing running from the handlebars on that side are the throttle cable and two wires from the kill switch and those are what I tried to bypass.
-
The kill switch has two wires leading from it. I have disconnected the harness and direct wired it to bypass the kill switch but that didn't seem to help. I have also bypassed the ignition but that...
-
Could you explain that one a little better so I can try it? Can a kill switch just go bad like that on it's own? It really does seem like the kill switch is pushed in even though it's not. I get...
-
Compression is fine, just not getting the spark. I have checked the fuel line, carburetor, and spark plugs and everything seems to be working. Just can't figure it out now.
-
Well all the switches are in correct position but I will have to start checking into the wiring I guess, which I really don't want to do. :)
-
I have an old 1991 Arctic Cat Jag snowmobile. It was not running for a few years and the mice took over. Anyway, I cleaned out the entire fuel system and carburetor and managed to get it running...
-
I found this answer on techrepublic.com and it worked great.
To resolve the issue, follow the steps below.
1. Right-click on My Computer, and select Properties.
2. Click on the Advanced tab....
-
I get the error message "SYSTEM ERROR The document cannot be printed due to a system error. Try printing again. If unsuccessful, restart Windows and try printing again."
I get this message...
-
I am trying to get an old sled running again. I had taken the top of the carb off in order to get the carb out for cleaning. In the process of cleaning things, I accidentally hit the throttle and the...
-
This is the one that I can find. I have an AO Smith model FPSH 40260. The thermocouple (part 183267) is included in this entire assembly which costs over $100. Is this the right or am I looking at...
-
Is there a way to test the thermocouple? It's a pretty spendy part. Thanks
-
Sorry, you're right. It is a gas water heater. I meant to say the ignition is electric or automatic.
So it is a bad thermocouple? Where is that located?
Thanks,
-
Bad title. I meant gas water heater.
Sometimes there is hot water and sometimes there is not. No pattern to it.
When we don't have hot water, I will turn the water heater off and back on. It...
-
I replaced the strut assembly and that seemed to be the issue regarding the placement of the wheel. It all looks straight. I know I will have to have it checked for alignment but it is driveable....
-
I have checked a few things. If I pull the wires off the items pictured, I still have continuity through the white thing with blue wires and the black thing with the red wires. I do not have...
|