Search:
Type: Posts; User: hawkeye088
Search:
Search took 0.00 seconds.
-
Did you completely disasemble the carb? There are many tiny orifices inside that can get shellac buildup from old gas. Also the diaphram on these carbs can get hard over time. The diaphram works as a...
-
An offset flange will not move the pipe. It will just move the toilet. If you just need the toilet to be away from the half wall it may be a solution for you, but if the actual waste line is blocked...
-
The doctor is his mother...
-
Ok Guys,
This will be quite a lengthy post, but I feel the more information the better. I will post this in three parts that can be answered in full or partial. First I will lay out a little...
-
I am also assuming this is on a riding mower. Correct?
-
Removing the nut with the impact wrench will not cause any significant harm, however, I am wondering how you got the flywheel off. Typically the flywheel has to be removed with a puller.
-
If you are using all of your old linkage, wires, etc. for the TBI then you should be fine as long as the relative location of things have not changed. I.E. the water neck is in the same location and...
-
You need to check the ports and plane of the intake manifold. The only real difference between the early model 350's and the vortecs are the heads. We have run dirt cars for years and as good old...
-
Did you remove the magneto? (the box the spark plug connects to)
First make sure the aluminum key in the crankshaft is completely intact and not sheared. Second, you got the key seated in the...
-
You can almost always paint latex over oil-based, and hardly ever get oil-based to perform over latex. If walls are texture sanding becomes almost impossible because of the rough surfaces. You can...
-
|