Search:

Removed ice bucket in freezer and see if there a lot of ice build up around the auger motor/shaft(look like a fork). Check and see if you turn the auger motor by hand,if not then your motor may be...

The part number for 1 speed motor is wh49x10029 and for 2 speed is wh49x10035
I do not have the price on them,but you can call GE part direct line @1800 626-2002
good luck.

Sound like the compressor is not running ,remove black cover near the compressor you will find a start relay and overload.a relay is a device that start up the compressor.You can check this by prying...

I would start checking the heat element to make sure they are not short to ground.The 4.4 k ohm only use during automatic cycle setting.That what reduce the 220 volt circuit to advance the timer...

You could possibly had a bad main motor that overheating.Usually lint build up inside around the motor causing it to overheat then shut down.There is an overload inside the motor that tripped when...

Change drum rollers, and seal locate at back edge of the drum.The gasket will come with high temp glue. Use heat gun to pull the old seal out.

F7 is a code for a shorted key panel(touch pad) .That is a push button number pads for all the functions(bake/broil/clock). It is not a contact on the board.

This might be a counter balance spring that hook to the Left rear of the machine.The short end hook to the bracket at the tub and long end is to the rear of the cabinet at the very bottom.You will...

You have a bad water pressure switch.The switch is sending signal to timer and thinking is full.

Do you have a model #s? Just open the door and it will be a model/serial plate on the left side.

How is the condition of motor shaft. The clutch is keyed to motor shaft.If is worn so much that the clutch will not staying on securely then it will come loose again.They have a new replacement motor...

Sound like the problem is in the timer.because the washer goes in to nuetral drain.It mean that it is draining without spinning the tub.The timer is what causing it pause and switch the tranny back...