Search:
Type: Posts; User: NaturalGasMan
Search:
Search took 0.00 seconds.
-
I apologize if I have offend anyone, all that I have been going off for the water content in the system is the federal standards set for pipeline distribution. Here is a link to verify if you would...
-
I would just like to clarify that I have never heard of any one even attempting to slope a gas line, for one it is a pressurized system, there is always verticalness and horizontals in a gas line....
-
Yea, noticed that a little to late myself. Thanks
-
I would agree with Keep it simple stupid, I would call your local gas supplier and have them send out a leakage inspector. I work for a gas utility and have never heard of combustion gases killing...
-
My kids say it was called GUNDUM, I hope this is correct. All three agreed which is rare. This was the answer to your question 1. They didn't have a answer for 2.
-
I am currently building a new cedar fence and have chosen "Preserva wood" stain.
I have used it before on other project fences and have been very pleased with the results.
My current fence I am...
-
Could possibly be as easy as the "O" rings going bad in the valve. Are the fleck metallic? Do they smush out when you touch them?
-
Working for a gas utility in the NW I am wondering where you guys are having so much trouble with mositure in your lines? Our system has spent many dollars installing dryers and filters in the...
-
Call around for a conversion kit, it will make your life much easier.
-
Well that is close to the correct answer, there is a step or two that you will need to do besides that. LP runs at a much higher pressure than NG. There for you will have to regulate the pressure...
-
If you read the instructions on the flex connector it states NOT to use any tape or sealant.
-
To piggy back on Northerheats answer, be very very careful with the venting and combustion air needed for furnaces to operate properly. Furnaces in MH are often installed in closets with combustion...
-
Sounds like your furnace is over heating, it is very common if you have dirty filter, to many registers closed, air return is block,clogged, or covered. Did you replace the motor for same size,...
-
Before you check the settings of the unit take a look at your gas supply. Many of the units sold require a higher gas pressure then utilities normally supply. Most utilities supply 6.5"wc standard...
|