Search:
Type: Posts; User: eagark
Search:
Search took 0.00 seconds.
-
Usually a blown motor will smell, or be hard to turn manually, (the blower wheel). Also, you can touch a 120v wire to any of the furnace wires except white, and leaving the white wire hooked up to...
-
.On the control board (down on the blower), you will see a fan-relay which is one of two square-ish plastic devices usually the largest of the things mounted on the control board. One of these is...
-
You seem to have a flame sensor problem. If this furnace is the one I think, as I am not as familiar with model #'s on York, you should be able to fix is quite simply. If you feel comfortable, get...
-
Have you tried to force run the condenser by manually depressing the contactor? I wondered if it ran at all when you described the problems. Also, you should have 24v between red and common on the...
-
This one may need looking at by a pro, but you may have a bad low voltage connection going to the contactor. The reversing valve will also make a distinct click, and the defrost cycle will usually...
-
The trouble with coleman type furnaces is the combustion air often creates a wind tunnel effect in the combustion area of the furnace which is sealed. An option is to get an updated flue cap which...
-
Often a inducer motor will rotate in reverse when no power is applied because of positive pressure up the flue which causes a windmill effect. If it continues in reverse when power is applied, then...
-
I am confused at the model # you gave. I think that those numbers refer to the heat strip on an air handler, and not the actual model of the heat pump. Please detail the problem and the type of unit...
-
It is dificult to diagnose this without more info, and possibly some tests. For instance, if you live at a significant altitude like Denver, it is possible the pressure switch cannot maintain a...
-
There is a chance you are actually looking at a very poor attempt to install the return air. I have seen some pretty shabby jobs in my experience, and never am surprised anymore. It is a simple...
-
You might have a reset button at the top of the furnace near the flue pipe that you can reset by pushing in at the center of the little circular button. If not, then the pressure switch may be...
-
My vote goes to the blower motor giving its last as it usually goes out with a strong smell. Usually an amp test will reveal a weak motor, but often it just burns up and eventually quits
-
If you toggle the switch on off and on, it should reset the ignition sequence. The fan may blow cold air for up to two minutes, so let it run at least that long, and then it should light. Check you...
-
I recently repaired an identical furnace with identical problems after replacing the pilot burner, it still acted up by intermittant lighting, and then going out. I found that a wire in the harness...
|