Search:
Type: Posts; User: Ninotchka
Search:
Search took 0.01 seconds.
-
1/4", but not plypanel, hardwood t&g slats.
That might be more suitable. Is there a name for the kind of foam? I'm not sure what to look for.
I recently found out that 1/4" drywall is...
-
Why? That will end up very thick.
-
This is an advice forum. What that person "offered" wasn't advice, it was invective.
I'm sure there are lots of personal opinions that I could merely state (mostly to do with people who think that...
-
As you can see, inappropriate posts are reported and dealt with rather quickly. :) Don't let the turkeys get you down.
-
If you are in CA you have quite a few options open to you that people in less progressive states don't have! Avail yourself of all the legal protection you can have (quite a bit). Go see a lawyer who...
-
A few small additions to everyone else's good advice:
Are there any community gardens where you live? For years before we had a house with a yard we gardened in community gardens. It's really...
-
I'm putting beadboard halfway up the wall in a room, two walls of which are masonry. One of the masonry walls is an exterior wall that is double-thick brick (almost 16" deep!). The other is an...
-
Hi! I'm putting in a GFCI receptacle in an old house. The wiring is 10ga and I'm having a really hard time working with it -- it doesn't fit well under the screws of the receptacle (Pass & Seymour...
-
Can you explain a bit about "bonded joint to pipe"? Does that solvent weld like PVC? I've never worked with ABS, why would you prefer it to PVC in this situation? Thanks very much!
Same...
-
I just (painfully) removed a chrome pipe + solder bushing from a cast iron hub. I bought a Desanco fitting to transition between the cast iron and a chromed brass tailpipe (this is for a wall-hung...
|